Thingiverse
Flashlight Magnetic Holder
von nthesign
3
Downloads
1
Likes
0
Makes
I present the design of the magnetic holder for the flashlight.
Handle dimensions are adapted to the Fenix LD15 flashlight (diameter 16 mm). Although it should also match other (larger and smaller).
To make the handle, you need round neodymium magnets (diameter 10 mm, height 2 mm) and cable ties (width up to 3 mm, thickness up to 1 mm).
To make the model I used PET-G to increase strength and flexibility, but PLA is also suitable.
layer height 0.2mm or less
infill 40% or more for increase endurance.
Enjoy :)
Handle dimensions are adapted to the Fenix LD15 flashlight (diameter 16 mm). Although it should also match other (larger and smaller).
To make the handle, you need round neodymium magnets (diameter 10 mm, height 2 mm) and cable ties (width up to 3 mm, thickness up to 1 mm).
To make the model I used PET-G to increase strength and flexibility, but PLA is also suitable.
layer height 0.2mm or less
infill 40% or more for increase endurance.
Enjoy :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
