Flashlight Mount for Ender 3 V2

This is a flashlight mount I designed and printed using fusion 360 and cura as the slicer. The inner diameter is 28.8. outer diameter is 40.09mm. I used it for a flashlight that has diameter of 28.3mm. It is tight fit so any flashlight with a diameter of 26mm-28mm will fit. I printed with 20% infill and it makes it extra sturdy therefore making the holder more difficult to remove and add onto my flashlight (mainly because of the diameter). Less infill will make it easier to put on and off, so you can try a 10% or less infill to make it easier to remove.

Post print I sanded the inner edge of the opening in order to make it easier to remove and replace on my specific flashlight.