Flat Baseplate for Everything Presence Sensor

TL;DR: Gives your Everything Presence sensor (One/Light) stand a flat surface, which can be more readily attached to a surface, using adhesives like nano-tape. Motivation:I've seen a few models which fully replace the ball mount that comes with the sensor.But they tend not to be quite as elegant as the original.This baseplate is a minimal addition to make the stock plate suitable for mounting with adhesives.Design:Mostly conforms to the contour of the sensor's stand, just adding 1mm on the underside (baseplate) and top (left/right flanges).For other purposes (e.g. making it heavier, or using longer screws) you might want to increase the thickness o baseplate.Assembly:Top flanges are attached to main body / underside using four M2.5 × 4 mm countersunk screws.You could probably customize model to use screws that are M3 and/or possibly 6mm in length.Be careful not to tighten with too much torque, as the hole is unthreaded.