Slicer Discord
Flat box for Geocaching – Modelo 3D imprimible de Thingiverse Thingiverse

Flat box for Geocaching

por LLSmurf
72 Descargas
35 Likes
0 Makes
Ver Modelo
These are 2 little, flat boxes for hiding geocaches.
The bigger box is 85 x 85 x 8.2 mm (plus hook).
The drawer is held in the box by 2 neodym magnets 5x5x3mm and 2 wood screws 2x12mm (Spax). A fitting logbook can be downloaded [here](https://www.marcelcuvelier.de/wp-content/uploads/2019/09/logbuch55mm.pdf).

The smaller box is 63 x 65 x 6 mm (plus hook).
The drawer also uses 2 neodym magnets 5x5x3mm and 2 nails 1,4x25mm to stay in place. A fitting logbook can be downloaded [here](http://www.cachelabel-generator.de/book.php).

In addition you will have to glue the top to the case. I normally use *UHU Allplast* or *UHU plast special* for this purpose. Please beware those boxes are not waterproof of course.

Update: As I had issues keeping the log book dry in the other boxes - my cache is exposed to full wheather, I design and uploaded a flat, round box, that so far proofed to be almost rain proof.
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
postproceso considerable
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, Wood PLA
Postprocesado
Pegado, Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

LLSmurf también publica en

5 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección