MakerWorld
Electronics
Model downloaden
Flat Panel Television Riser Blocks
62
Downloads
19
Likes
28
Makes
Flat Panel Television Riser BlocksIf your sound bar blocks the bottom of your screen, or your remote control is not working, you may need to raise up your TV. This is for panels that sit on the two chicken type feet. Check to see if the feet on your screen fit into the pocket of this block that measures 30mm x 190mm. This prints easy with no supports. I made mine out of PLA. If you use this in a warm climate, consider using something better than PLA. UPDATE: 6/17/25Added a second version that is sized to fit the narrow feet on a LG 42" C2 OLED TV (173 x 8 MM)Measure your TV feet to check fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
