Thingiverse
Flat SD card holder
von Ummon
27
Downloads
31
Likes
0
Makes
This is my take on a sd card holder which :
- sits flat in the back pocket of my camera bag (already bulgy enough from batteries)
- holds the cards without need to open lids or screws
- protects the contacts
- lets you see the label on the cards
In order to make it as flat as possible, I made it not very sturdy - but it is meant more as an organizer than as protection and did that well for a year of sporadic (Corona) use, and I was happy to have it.
I only tested it in PLA, printed with a 0,4 mm nozzle and 0,1 mm layer hight, which seems already sufficient. I guess excessive elephant´s foot could have negative impact on the use of the springs and should be avoided.
- sits flat in the back pocket of my camera bag (already bulgy enough from batteries)
- holds the cards without need to open lids or screws
- protects the contacts
- lets you see the label on the cards
In order to make it as flat as possible, I made it not very sturdy - but it is meant more as an organizer than as protection and did that well for a year of sporadic (Corona) use, and I was happy to have it.
I only tested it in PLA, printed with a 0,4 mm nozzle and 0,1 mm layer hight, which seems already sufficient. I guess excessive elephant´s foot could have negative impact on the use of the springs and should be avoided.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
