flathead cup holder

I made this cup holder for my uncle, and I am very pleased with it.

I done this in 2 different prints, the block and the pulleys/belt, I then glued the two together. I didnt print the block with a brim. I also printed the block with supports on the bed only, besides the supports I built into the model. You can use a set of side cutters to clip the built in supports off.

Speaking of built in supports, in one of the photos I circled with green a defect in the print. The support fell over for this section, not sure if this was from too fast of infill, too small of support, or not using a brim. In the stl I uploaded I made the base of the support quite a bit bigger, so this shouldnt happen to you. Im not going to reprint this model, after gluing on the pulleys you cant see the defect and this model used quite a lot of pla, but if you print it, I would appreciate it if you let me know how it turned out.

The Ender 3 has a notoriously heavy bed, and I had the infill speed