FlexBall (printed with NinjaFlex)
por SleepyFrog
26
Descargas
10
Likes
1
Makes
I bought NinjaFlex filament and was searching for a simple print to try it out. I found this:
https://www.thingiverse.com/thing:821858
But the results were quite disappointing. However, I liked the idea of a little ball that can be squeezed, so I end up creating my own version. This was working much better (and my cat like it as well).
Attention:
The design is quite small, so you probably want to scale it up to make it bigger. The one you see in the picture is done with 250% of the original size.
https://www.thingiverse.com/thing:821858
But the results were quite disappointing. However, I liked the idea of a little ball that can be squeezed, so I end up creating my own version. This was working much better (and my cat like it as well).
Attention:
The design is quite small, so you probably want to scale it up to make it bigger. The one you see in the picture is done with 250% of the original size.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
