Flexi Capy Snek

Articulated Skeleton 'Snake' with a Capybara SkullVersion 1.3 - 12 VI 2025 Capybara Skull is followed by 33, 22 or 14 spine segments - depending on versionSnakes are 188mm, 133mm and 92,5mm long Model with 33 segments is in ARC version that will fit even the smallest printers (70x70mm size)You can resize it up to make a very big snake (on typical printer you can go up to around 280%)Version with 14 segments is with two keyring modelsFront is with removed back teeth and connected front teeth to the jawBack is with last segment changed to one with a hole--- Check my LinkTree in my profile description for a commercial license if you want to sell prints of this modelsI also have more flexi toys in my profile---Printing tips2-3 walls No infill needed (use some for better strenght, especially when printing a resized model)No supports needed You can resize it up as you like Resizing down is not recommended but you can try it with smaller nozzle if you want to make earrings for example Break possible connections between segments after print With a clean print it will be moving like it should streight from the bed plate --- You will need a good bed adhesion to print it without any problems - The best would be to use a glue stick Most difficult is front teeth part - it's small and it's also supporting a front part of a skull Brim to the whole model is not recommended (too much work with removing it) If you need some help with adhesion of front teeth use 'Teeth-Brim' or 'Teeth-Joiner' modelsTeeth-Brim will add 2-3 walls around teeth on the first layer, just like regular brimTeeth-Joiner, when merged with base model, will connect front teeth with the rest of skull. This will be easier to printIgnore model errors - there is a flat part to help you line up the model with CapySnek Also click 'NO' if the slicer will want to automaticly resize the model - it's with the right size---