Thingiverse
Flexible Handcuffs
por protokinetic
752
Descargas
557
Likes
1
Makes
##Story
This is a major revision of my existing dual handcuff design. The benefit of this is that it only requires one lock making it much lighter and easier to put on. This is just version one right now but I will probably have a couple more revisions to come before moving on to my next project. I felt this deserved its own submission because it was designed from scratch and there might still be some coming revisions of the two lock version.
This one is also slightly harder to use as its security is predicated on the the length of the locking the bar used. The distance from edge to edge of the locking zone (the middle) is 22mm so I recommend not using locking bars much longer than that as it will loosen the cuffs. The lock I have used is the Master Lock 140D and worked reasonably well. I will continue testing and update the design if needed. Also any locks you find that work well, please leave them below so that others might have more guidance.
##Dimensions, Print Time, and W
This is a major revision of my existing dual handcuff design. The benefit of this is that it only requires one lock making it much lighter and easier to put on. This is just version one right now but I will probably have a couple more revisions to come before moving on to my next project. I felt this deserved its own submission because it was designed from scratch and there might still be some coming revisions of the two lock version.
This one is also slightly harder to use as its security is predicated on the the length of the locking the bar used. The distance from edge to edge of the locking zone (the middle) is 22mm so I recommend not using locking bars much longer than that as it will loosen the cuffs. The lock I have used is the Master Lock 140D and worked reasonably well. I will continue testing and update the design if needed. Also any locks you find that work well, please leave them below so that others might have more guidance.
##Dimensions, Print Time, and W
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
