FlexiStruder

I have recently started having some problems with my EZstruder, on my Kossel Pro, after hundreds of hours printing. It began with the odd missed layer or section that meant scrap prints - most annoying. What was happening was that the small, ballrace was slipping sideways off the filament every now and again causing the feed to stall. I have to admit to doing most of my printing with the clear cover removed for ease of maintenance. However, even with the cover replaced, there was enough movement to allow the bearing to keep slipping off the filament. It appears the red, lever arm was getting fatigued and the thin section, around the pivot, was just too thin and was allowing far too much movement.

I started by wanting to modify the EZstruder bowden clamp but it was impossible to drill it out 4mm, to allow the PTFE tubing to pass through, without destroying the thread. I re-designed it to allow the EZstruder, aluminium, bowden clamp fitting to be used but this still meant the end of t