Flight Controller box for VAS Banshee

Needed somewhere to put my flight controller on my second VAS Banshee, so I built this.
it fits the on the bottom side of the airplane, just have to cut out the EEP buckout for the ESC.
Its close to but a bit aft of the CG on this plane. I used M3 screws from the underside of the of the print to attach short stand offs to hold the FC.
Look at the pictures and you can see how I cut the EPP. The Lid is held in place with #2x 1/2" screws from the hardware store. The sides are open to allow you to still attach a USB to the FC (and in my case, the FTDI to the on board OSD)
The FC is on here just so that I can run Sbus from my ImmersionRC EZUHF and so that I can Have an OSD with the GPS. I have yet to fly this airplane, but I have done a ton of flying with my other banshee, and it's a wonderful plane for flying. I always get the question, "how fast are you flying?" With this setup I will have an answer.
I printed in hatchbox bule ABS, because that's what I had loaded on the printer.
I