Flik Wing Removable Adjustable Motor Mount

Here is a simple straight forward motor mount for the flik wing that allows you to easily remove or swap the motor. It also has some different options for moving the motor further out. It is only about 2mm longer than the standard mount at it's smallest configuration. Just glue the exterior mount to the foam where the standard mount goes and the portion that the motor mounts to gets slotted in and retained with a m2 bolt through the both. Use a filament that has a little more heat tolerance than pla. You may need to play with the scaling by a percent or two on the outer portion to get a nice fit depending on how your printer prints. With my p1s the standard tolerances that are built into the design were enough for a fit needing a small amount of force to insert and remove the motor portion.