Flint2 Router Stand + Modem

I couldn't find a stand to stack my Spectrum ET2251 modem and GLi.net Flint2 router that I liked. Never done anything in CAD before so this is my first design. The base helps hold the legs and keep them from splaying. It also has a lip on the left side to hold the modem from pushing too far to the left. The base extends under the modem to make it look a little nicer. The bottom can be a bit warpy but will be fine once the legs are popped in. There is a little ramp that can be inserted to “level” out the modem since it's not a rectangle. The rubber feet on the Flint2 should be on the shelf with plenty of room for air to get in underneath. I have no idea how well it will work I just tried what appeared to make sense.