Slicer Discord
Flip-out Coat Hook – 3D-Druckmodell von Thingiverse Thingiverse

Flip-out Coat Hook

von ottaross
208 Downloads
160 Likes
2 Makes
Zum Modell
Flip it down to hang a coat, or hook a clothes hanger over it. Seems suitable in your laundry room, or near your ironing board. Probably good for your workplace too, where you can flip it down to hold your coat during colder weather.

Could probably hold your headphones when you're not using them too. Your VR headset?

Seems to take a #6 wood-screw pretty well.

This started life as door stop for a sliding door, but I realized it would work nicely as a flip-out-of-the-way coat hook too.

So a couple of changes, just to emphasize the hook part, and perhaps retain a hanger better if you were to hand a shirt or jacket on it, seemed like nice additions.

Makes me think there are likely some other flip-down-to-use applications that we could remix this little guy into. Any ideas?
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Wood PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen