Flipper Zero - Wi-Fi Dev Board Case (Basic)

This print is specifically designed for the basic WiFi board straight out of the box, omitting features such as the antenna and SD card slot.

This creation is a remix of magdong's Wi-Fi Dev Board Case (https://www.thingiverse.com/thing:5564906).

For secure assembly, utilize 4 x M3x12mm screws accompanied by 4 x M3 nuts.

This design also has a pin protector boot cover that can be found in the following locations:

- https://www.thingiverse.com/thing:6104552
- https://www.printables.com/model/606861
- https://github.com/CodyTolene/3D-Printing/tree/main/Flipper%20Zero%20-%20WiFi%20Dev%20Board%20Case%20Boot%20Cover
My print settings:

- Hatchbox PLA
- 0.2mm layer height
- 0.4mm nozzle (line width)
- Enable retraction
- Wall count 3 (+ print thin walls enabled)
- Top/bottom layers: 4
- Infill density: 20%
- Infill pattern: Cubic
- Print temp 200 C
- Bed temp 60 C
- No supports needed

See more designs on my GitHub here: https://github.com/CodyTolene/3D-Printin