Thingiverse
FLIR Backfly - Stereo System Support
von xris
0
Downloads
0
Likes
0
Makes
This design is a mount for a set of two FLIR Backfly S cameras, for calibration and use as stereo cameras. In addition, I have added metric 4 holes for insertion into 20x20mm profiles or 20x40mm profiles.
v2: Added a gap to hide the camera fixing screws
v3: Edited to eliminate surface area and reduce printing times
Printing:
For printing I recommend the use of brim and an infill higher than 50%, in order to adequately support the camera lens. In addition, I recommend printing at an angle, so that it is more resistant to the force between the profile and the camera.
v2: Added a gap to hide the camera fixing screws
v3: Edited to eliminate surface area and reduce printing times
Printing:
For printing I recommend the use of brim and an infill higher than 50%, in order to adequately support the camera lens. In addition, I recommend printing at an angle, so that it is more resistant to the force between the profile and the camera.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
