Flirc case stacker

Simple rack to tidy up things with my raspberry´s.

Adding acrylic front and side panels is just an option. I used 2mm thick ones cut to a tight fit.

Cooling with the 120mm fan makes my RPI 4b 8gb run at about 40 celcius. Could be cooler if i removed side panel.

Make sure you mount the 120mm fan as far back as possible so you are able to plug power in. Also fan is just mounted with doublesided nano tape.

I will redesign this in future so the HDMI ports are accessible aswell. I run all my pi´s in headless mode so i had no need for them.

Printed on its side with support touching buildplate. Near the end of the print when it had to bridge it wasn´t perfect, but it was enough for me.