Thingiverse
Flite Test Firewall
door MikeTitor
133
Downloads
85
Likes
0
Makes
Yet another Flite Test firewall. Use in place of the plywood firewall Flite Test designs use. Will fit the standard FT power pod and swapable power pod.
Intended for brushless electric motors. Probably not suitable for gas engines.
Note: I model knowing the limitations of my 3D printer. Its old and has a few minor quirks. In general its accurate but holes especially tend to print out smaller than they are sized in the model. As such I model holes slightly larger to accommodate this. Test print any part and make sure any attached hardware like wire or skewers fit properly before bulk printing.
Intended for brushless electric motors. Probably not suitable for gas engines.
Note: I model knowing the limitations of my 3D printer. Its old and has a few minor quirks. In general its accurate but holes especially tend to print out smaller than they are sized in the model. As such I model holes slightly larger to accommodate this. Test print any part and make sure any attached hardware like wire or skewers fit properly before bulk printing.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
