Slicer Discord
Floatant Caddy – 3D-Druckmodell von MakerWorld MakerWorld
Sport & Outdoors

Floatant Caddy

96 Downloads
36 Likes
54 Makes
Zum Modell
When fishing dry flies, it's useful to have both a powder desiccant (Shimazaki Dry Shake, Loon Top Ride, etc) and a liquid floatant ( Gink, Aquel, etc). Rather than fish them out of pockets, this caddy holds both and clips on to a vest or pack loop. This caddy was designed to fit loon's top ride and aquel floatant, shown below with a short piece of elastic cord and a small carabiner.Knot one side of the cord and pass thru the back of the caddy. Loop around the front and pass thru the second hole and knot.It should fit snuggly below the cap of the Top Ride.After making sure your Top Ride is capped tightly, flip the caddy over and insert the Aquel with its cap off.Then tighten the Aquel cap.Insert the small carabiner (or other attachment: cord, snap swivel, etc) thru the top hole and attach to your vest or pack.
Kategorie
Sport & Outdoors
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen