Thingiverse
Floating Pyramid LED-ready
36
Downloads
10
Likes
0
Makes
Was printing Giandroid's Version of the Floating Pyramid for a friend as I came to think that it would be awesome with some LEDs.
So I set about modifying the necessary parts to fit 5mm LEDs. Also I changed the portal a bit by adding some tiny steps and trying to recreate the original twirling portal. I have printed everything and it should basically work. But it is not fully assembled so I will keep this a WIP.
NOTE: These are only my modified parts which replace the corresponding parts of Giandroids Version. So you still need to download his files.
For the LEDs to work you will need to print some of these parts with translucent Material. I found some bright green PLA, basically exact Necron colour. But you could go with blue or whatever you like.
You will need some 5mm LEDs (26 of them to be precise). You will have to figure out a circuit for yourself, but the internet is your friend. The hole in the bottom plate is for a switch to turn it on from the outside.
Also the e
So I set about modifying the necessary parts to fit 5mm LEDs. Also I changed the portal a bit by adding some tiny steps and trying to recreate the original twirling portal. I have printed everything and it should basically work. But it is not fully assembled so I will keep this a WIP.
NOTE: These are only my modified parts which replace the corresponding parts of Giandroids Version. So you still need to download his files.
For the LEDs to work you will need to print some of these parts with translucent Material. I found some bright green PLA, basically exact Necron colour. But you could go with blue or whatever you like.
You will need some 5mm LEDs (26 of them to be precise). You will have to figure out a circuit for yourself, but the internet is your friend. The hole in the bottom plate is for a switch to turn it on from the outside.
Also the e
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!