Thingiverse
Floating Shelf Keyhole
von PartayPat
68
Downloads
54
Likes
0
Makes
This is an insert that allows you have floating shelves with no visible screw holes. It works well as long as it doesn't need to take much weight. The corner shelves can take much more weight but are a bit more fiddly to implement.
The part is screwed into a hole in the back side of the shelf. As long as you drilled the hole straight (I was doing it by hand) the teeth will grip and lock the orientation of the part. The shelf now has a "keyhole" feature in the back of it that can slot over a screw in the wall. By altering the depth of the screw in the wall you can get a nice tight fit.
Print with keyhole side up.
Directions
Using a 16mm spade bit drill holes AL 15mm deep.
Drill pilot holes for the screw.
Check CS screws will both fit in part.
Put screw in part, align orientation and tighten screw until the part is pulled flush or deeper. (put screw in first! - don't just hammer it in)
Accurately mark up the hole positions on wall.
Drill holes in wall and insert wall plu
The part is screwed into a hole in the back side of the shelf. As long as you drilled the hole straight (I was doing it by hand) the teeth will grip and lock the orientation of the part. The shelf now has a "keyhole" feature in the back of it that can slot over a screw in the wall. By altering the depth of the screw in the wall you can get a nice tight fit.
Print with keyhole side up.
Directions
Using a 16mm spade bit drill holes AL 15mm deep.
Drill pilot holes for the screw.
Check CS screws will both fit in part.
Put screw in part, align orientation and tighten screw until the part is pulled flush or deeper. (put screw in first! - don't just hammer it in)
Accurately mark up the hole positions on wall.
Drill holes in wall and insert wall plu
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
