Floating Star Passive Multiple

This is a floating star passive multiple for use with thonkiconn jack sockets.

Hardware needed:
6x thonkiconn mono-jack
1x M4 bolt 10mm in length
1x M4 nut
Wire, solder, soldering iron.

Instructions:
1) Cut the R-leg of all thonkiconn jacks as we don't need it and it could easily be shorted to ground.
2) Place thonkiconn's in the rectangular holes of one of the printed pieces, so that the ground leads of two neighbouring jack sockets are pointing towards each other. The other side should have the signal leads pointing towards each other. This will make it easier to solder everything together.
3) Use three short wires to solder all the ground leads together in a triangle pattern.
4) Do the same for the signal leads.
5) Put the other half on the assembly.
6) screw the two halves together with the nut and bolt.