Thingiverse
Floatwheel ADV Power Switch Cover
von supzero
5
Downloads
4
Likes
0
Makes
A power switch cover for the Floatwheel ADV. Not sure if it will also fit in the ADV Pro. The power button is supposed to be waterproof I think, but if you also want to keep mud and other dirt away from the button, this should work.
The idea is that the plug stays in place and can be pulled out easily with two fingers. If it falls out, or you need tools to pull it out, you may want to make the diameter a but larger or smaller. I assume some printers will be exactly the same, and the sizing is important for this thingi to work.
I printed it in PETG, so it doesn't get all soft in the sun.
The idea is that the plug stays in place and can be pulled out easily with two fingers. If it falls out, or you need tools to pull it out, you may want to make the diameter a but larger or smaller. I assume some printers will be exactly the same, and the sizing is important for this thingi to work.
I printed it in PETG, so it doesn't get all soft in the sun.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
