Thingiverse
Flood Light Lamp
von MathMessiah
2
Downloads
2
Likes
0
Makes
Indoor/Outdoor Flood Light Lamp.
It's a ghetto lamp! I got a great deal on these flood lights and decided to make them into lamps.
I'm not sure if this would be a good fit for other sockets, but it should work for smaller sized sockets.
Printing
I printed the top and base separately and then used Gorilla Super Glue Gel to complete the assembly. This saved me quite a bit of support printing plastic/time.
If can't be bothered to glue, the full part is included.
Filament: Hatchbox True Black PLA
Layer height: 0.2mm
Nozzle: 0.4mm
Infill: 20%
Supports: Yes (45 deg)
It's a ghetto lamp! I got a great deal on these flood lights and decided to make them into lamps.
I'm not sure if this would be a good fit for other sockets, but it should work for smaller sized sockets.
Printing
I printed the top and base separately and then used Gorilla Super Glue Gel to complete the assembly. This saved me quite a bit of support printing plastic/time.
If can't be bothered to glue, the full part is included.
Filament: Hatchbox True Black PLA
Layer height: 0.2mm
Nozzle: 0.4mm
Infill: 20%
Supports: Yes (45 deg)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
