Floor Cable Cover

Running a cable across the floor is never a good solution but sometimes there is no alternative this is intended to at least reduce the trip hazard it creates.

### Dimensions

- width : 40mm
- length : 50mm, 170mm or 300mm
- inner diameter for cable : 5mm

For my use case this was intended for a 5mm ethernet cable however you can modify the fusion or step file included to get different sizes. It is a very simple model one sketch and one extrude. Also if you want to get a shorter length for some final section you can just stop the print early.

### Printing

You can print it in vase mode to save on plastic it will still join up in the center and the cable it self will give it structural strength. I printed it vertically to allow for a smooth upper curve if you do the same make sure to use a generous brim width.

### Installation

I have added some images of the installing process I recommend using some paper so the tape does not stick to the cable.

This model is desi