Flora IV-12 VFD clock

This is an enclosure for my Flora IV-12 VFD clock. It's super thin and just looks gorgeous! You can choose between printing the top base as a single piece in light color, or printing it in two colors which can result in visually nicer look but is significantly more difficult.

**Project github:**
https://github.com/mcer12/Flora-ESP8266

**Printing settings:**
- Layer height 0.2mm
- Line width 0.5mm
- No supports required
- I personally very much like the new beta version of Cura arachne engine which prints much better than normal Cura.

#NOTES FOR SINGLE COLOR PRINT:
- you should print it with something white or light gray which will let the light through at 1 layer thicknes (for the colon dots). I personally have a great experience with Stoneage Light from Spectrum filaments.

#NOTES FOR TWO COLOR PRINT:

It's highly likely you will have to do a few test prints before you get a handle on it. It requires perfect bed leveling for it to succeed as well as good understandi