Thingiverse

Floss 2 GoPro Session Mount (35 Degrees)

di Airmaxx23

53 Download

42 Likes

0 Makes

I searched around and couldn't find any GoPro Session mounts for the Hyperlite Floss 2 frame so I used my GoPro Session sleeve (found here: https://www.thingiverse.com/thing:2852274) and added the base. It has a 35 degree tilt and is mounted by using longer screws in the front standoffs and a short screw that goes through the rear of the case and top plate then held in place with a nut. I'm using a plastic (nylon) nut in hopes that it would break before the top plate in a bad crash. Please print this as it's shown in the render, no support are needed. This weighs 19 grams when printed with a 35% infill.

June 6, 2018: Added a second version with a slight cosmetic change.

floss Floss 2 GoPro guard hyperlite mount Protection protective session session 5 sleeve floss Floss 2 GoPro guard hyperlite mount Protection protective session session 5 sleeve

Fonte

Thingiverse

Cosa serve per stampare: Principiante Bassa affidabilità

Perché?

senza supporti

Senza supporti Pezzo unico Viteria richiesta

Supporti 0/3

Assemblaggio 0/3

Impostazioni 1/3

Dimensioni piano 0/3

Post-lavorazione 1/3

Stampante

FDM / FFF

Formato file

STL

Materiale

PLA, Nylon

Post-elaborazione

Viteria

Software

Cura, PrusaSlicer o simile

Ancora nessuna valutazione

Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti

Floss 2 GoPro Session Mount (35 Degrees)

Modelli simili

Aggiungi alla collezione