Thingiverse
Floss Dispenser
von yellowbus
12
Downloads
8
Likes
0
Makes
This is a floss dispenser designed to hold one floss handle and 14 refills. It has a built-in drainage system in case it gets wet. Recommend adding small rubber. It was modeled based on the Listerine UltraClean Flosser (formerly Reach). It may work for other brands but haven't tested any others.
No support is needed.
This is a 4 hour 17 minute print on the Prusa MINI+ (40mm nozzle, 20mm layer, 15% infill). It uses about 43 grams of filament.
Dimensions: 150mm long x 30mm wide x 68mm tall
Original design
No support is needed.
This is a 4 hour 17 minute print on the Prusa MINI+ (40mm nozzle, 20mm layer, 15% infill). It uses about 43 grams of filament.
Dimensions: 150mm long x 30mm wide x 68mm tall
Original design
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!