Flow Pot

Flow Pot Functional, sleek plater Printing recommendations & Assembly I Highly suggest PETG or ASA if your print will be outside(Note: direct contact with soil is not ideal, as it may block the drainage holes—unless you place a small filter above them.) Alternatively, Matte PLA with fuzzy skin(Process>others>Special mode>fuzzy skin>Contour) can give your print a more professional finish. The planter is made of two parts: The pot The water reservoir base (mandatory) Assembly is super simple—just stack the pot on top of the base. They align perfectly. Scaling & Dimensions If you need the the planter for small plants or bigger plant you can adjust the scale of the models from 33% to 150%. I don't recommend going beyond this range, as the water hole may become too large or too small. 📸 Images shown are from a print scaled to 85%, using Anycubic black PETG. ‼️IF YOU NEED A BIGGER VERISON PLEASE LET ME KNOW IN THE COMMENT‼️ Standard dimensions: Pot: External 80×80×82.5 mm / Internal 74×74×77 mm Base: External 80×80×13.4 mm Combined: 80×80×87 mm For any question or suggestions feel free to leave a comment or send me an e-mail at:📧 [email protected]