Thingiverse
Flower Pot
0
Downloads
0
Likes
0
Makes
Just a flower pot.
I personally recommend that you print it with a 100% infill so the water doesn not drip out.
If you decide to print it with a 20% infill, I suggest you to use some tipe of sealer.
I personally recommend that you print it with a 100% infill so the water doesn not drip out.
If you decide to print it with a 20% infill, I suggest you to use some tipe of sealer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
