Flower Spinner

Just in time for Mothers Day!!
This design like my others will either accommodate 3/4" X 3/16" button magnets or three pennies.
I like using magnets because you can use them to make each other spin, stick to fridge, etc.
To insert the weights just pause at the corresponding layer at the top of the magnets or pennies in each hole. "you don't have to add the weights but they will not spin as long"
I did not include spinner caps because there are already plenty of good designs.
The caps shown are Large Finger 608 Bearing Caps - by Wingnut2k.
Although I did have a hard time getting his caps to print well.
I may design some at a later time.
You can get the magnets at most craft stores, I picked up a 52 pack at Walmart for $6.

Designing and uploading projects takes a lot of time please leave a comment and/or tip if you can. Thanks

Tips:
Do not use supports otherwise your holes will get filled up.
Depending on your software use the option to not cross the outline for travel