Flowtech Nozzle for Honeycomb Storage Wall

Simple nozzle holder for the microswiss flowtech that sits on the honeycomb storage wall.any nozzle that is smaller than 6.5mm will fit that is the size of the nozzle hole.there is 2 plates.plate 1 has spots for 8 nozzles. but no spot for the microswiss plastic nozzle tightening toolplate 2 has spots for 6 nozzles but has a spot on the front for the plastic nozzle tightening tool. this tool's hole is 7mm supports on build plate for the honeycomb pieces. No other special parameters are needed.the included print profile is set for archane wall generator because i think its neat. 0.20 height2 walls15% gyroidtree supports enabled on build plateand 1 wall on first layer. none of these are required. except supports so change to suit your needs. yupprint kewl stuff