FLSun Cube Bed Level Adjustment Tool

This is a simple tool to adjust the level of the bed of a FLSun Cube. Likely,
it can be used with other printers such as the CR-10.

Print two tools and use then on both sides of the bed as shown in the picture.
It will be a pretty good starting point to level your bed.

Support is not required. The infill can be set to as low as 10%.

This object main web page is:
http://www.ctheroux.com/flsun-cube-bed-level-adjustment-tool/.

You can request the source files on the page listed above.