Thingiverse
FLSun Q5 Volcano Leveling Sensor Extender
por MiataCory
9
Descargas
1
Likes
0
Makes
Used to extend the leveling sensor on a Q5 with a Volcano hot-end.
No guarantees it'll work for you.
The idea is that you unscrew the magnet on the stock one, friction-fit this in it's place, then screw the magnet into the center hole on this part.
Printed with the 'small' side down, line supports (for the overhang). This ensures the inside is a nice, tight fit to the magnetic pieces.
No guarantees it'll work for you.
The idea is that you unscrew the magnet on the stock one, friction-fit this in it's place, then screw the magnet into the center hole on this part.
Printed with the 'small' side down, line supports (for the overhang). This ensures the inside is a nice, tight fit to the magnetic pieces.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!