FLsun QQ Enclosure

The way the FLsun QQ is designed makes it easy to enclose it. Printing ABS is
possible with this enclosure.

The printer sides are covered with a five mm tick board, 31.4 x 66.6 cm. The
corners of the panels have notches cut into it. The notches are 8 x 13 mm. A
helpful template tool to cut them is included. You need to print three sets of
these files except for the tool.

The panel I used is foam boards. Use another material since it can be a fire
hazard. A more rigid material is preferable. I had to glue some reinforcement
as shown in the picture. The boards are five mm tick.

The brackets are slightly slanted to fit the printer's shape. So, a given
bracket goes only in one of the four corners.

The brackets are held to the printer using the screws that retain the vertical
rounded panels.

As mentioned by https://www.thingiverse.com/Bebop33, the extruder will hit
the walls if you print an object larger than 22 cm in diameter.

Support that touches the build plate