FLSUN SPEEDERPAD CASE

Description ⚠ UPDATE ⚠ Following numerous feedbacks, I upgraded the upper and lower shell in a third version (Flsun Speeder Pad V3). In this version the tolerances are softer and reinforcements have been added to make the body more solid. ---------------------------------------------------------------------------------------------------------------- This case is designed to replace the stock one on FLSUN's SpeederPad so that it can take full advantage of all the ports soldered on the board but not accessible with the original case. In addition to the standard ports accessible on the PAD are added: - USB 4 - Micro USB OTG - UART Port (on the back) In addition, additional openings have been made both for the possible installation of an ETH RJ45 port for which there is a free slot, and a hole to be able to install a wifi antenna in order to increase the reception range that is very lacking on the device. For assembly were used the two stock screws found on the original shell, and in addition two more of the same to give more rigidity to the structure and eliminate the snap-in joints found on the stock version. There are mainly 2 versions: - Full Shell - Shell with flap In the first case, the shell is fully printable in two unique pieces, front and back, while in the second case a flap is designed so that it can be easily interchangeable.    Four flaps have already been made: - Standard Cooling flap is the standard version - Improved Cooling flap is the version with a wider mesh pattern so as to allow better air exchange, suitable for warm environments and climates - Fan Cooling flap is the version made to be able to install 40x40x10 or 60x60x10 fans (or greater thickness if desired) - Full Base Flap is the completely full version made to allow everyone to customize it the way they prefer, the .step file of this one is also included. Upon request, I have also included a modified version so that it does not have the openings for the Ethernet port and another with both no