FLSUN SR Pulley Stabilization

This model was made to help reinforce the idler pulley of the flsun sr delta gantry. We be swapping two of the components: Idler → 20T pulley | 25mm Screw M5 → 30mm Screw M5The printed stabiliser should be printed solid (mostly walls). I printed using Nylon-CF but you may use ABS, ASA, or PETG if you must. DO NOT USE PLA due to deformation and loss of rigity over time from heat and strain. New Hardware List:30mm M5 Screw - The original screw was a bit short for my design. Can be found anywhere but here's what I used (Amazon Affiliate Link - I earn a commision at no cost to you if you used this link): https://amzn.to/47971Yr(Highly Recommended) - GATES gt2 10mm wide belts (4 Meter length) - MAKE SURE TO GET AT LEAST 4 METERS OF BELT!!!! Cut each to 1250 millimeters long x3. Should match length of original belts): https://www.aliexpress.us/item/2251832667244886.html?spm=a2g0o.order_list.order_list_main.23.21ef1802L7NqOv&gatewayAdapt=glo2usa 20T GT2 Pulley 10mm wide (6mm BORE REQUIRED