Fluke 73 III Wall Mount

This is a replacement for the factory kick stand that allows this mod to be fully reversible. To install just pop the device out of the yellow rubber case, pop out the kickstand and install my kickstand.

I have a seperate plug that gets installed in the hole - this was done to allow for printing with no supports needed. I had to do a tiny bit of sanding for it to have a nice fit. The plug is 18mm long, 9mm goes in the hole and 9mm sticks out.

Printed in PLA+ on a tevo tornado @ .2mm layer height with 50%+ infill and 2 wall layers. Its strong enough for me but keep in mind its only 2mm thick so don't slam it around.