Thingiverse
Fluke77 Knob
von btoktamis
8
Downloads
3
Likes
1
Makes
Just my design of a Fluke 77 dial i had access two of them both with broken knobs.
You'll still need the delrin (teflon) part and flexible yellow part.
And two 2.5mm or 3mm or something similar screws for this to work
IMPORTANT NOTE: please do not use it on anywhere where you need the CAT rating if your selection of the screw is to long it may touch contact points inside
Disclaimer: Any harm done due to using this thing is your own responsibility
please do not use if you are not sure thanks
You'll still need the delrin (teflon) part and flexible yellow part.
And two 2.5mm or 3mm or something similar screws for this to work
IMPORTANT NOTE: please do not use it on anywhere where you need the CAT rating if your selection of the screw is to long it may touch contact points inside
Disclaimer: Any harm done due to using this thing is your own responsibility
please do not use if you are not sure thanks
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
