Thingiverse
Flush snap-on v-slot insert
por JimCnc
8.4k
Descargas
4.6k
Likes
24
Makes
Flush fitting snap-on v-slot inserts for 20mm aluminum extrusions which use very little material, no tools/disassembly required. Fits most 3d printers with aluminum extrusions such as Creality printers, i.e. Ender 3 V1 and V2.
There is a 7 clips version and a 15 clips version. I used the 7 clip version and it stays in place just fine. There is also a thick version of both models, which has thicker clips for a tighter snap if needed. All models are 100mm long, you can scale it up along the y-axis to the size you need. You can print them slightly too long and cut them to length with sharp sidecutters, as mentioned by Endersiastic in the comments.
**Changelog:**
20210409: I added the same models with thicker clips in case you need a tighter snap.
**Print settings:**
- 0.12 mm resolution
- 0% infill
- 4 bottom layers
- 0 top layers
- 2 wall lines
- Material: PLA
- For esthetics you can make the initial bottom layer concentric.
There is a 7 clips version and a 15 clips version. I used the 7 clip version and it stays in place just fine. There is also a thick version of both models, which has thicker clips for a tighter snap if needed. All models are 100mm long, you can scale it up along the y-axis to the size you need. You can print them slightly too long and cut them to length with sharp sidecutters, as mentioned by Endersiastic in the comments.
**Changelog:**
20210409: I added the same models with thicker clips in case you need a tighter snap.
**Print settings:**
- 0.12 mm resolution
- 0% infill
- 4 bottom layers
- 0 top layers
- 2 wall lines
- Material: PLA
- For esthetics you can make the initial bottom layer concentric.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
