Flux Chamber Drip Tip

A tiny expansion chamber for vaporizers that has 2 chambers connected by 3 'macoroni' tubes that gives a drip free vape hit. Designed to work without the need for a rubber ring, just rip a piece of paper or T.P. and fold it and wet it and set it on top of the hole where the drip tip goes and press the Flux Chamber into the vape for a perfect fit. The 3 tubes arent aligned perfectly so i hope it doesnt bother anyone's OCD too badly lol.
I didnt use supports on mine and they came out fine, just a little droop at the bottom of the tubes but i think that was cuz my printer nozzle.


USE PLA as ABS can seep toxic stuff into ur vape!
Print @ 100% infill and .2mm layer height.
Brim might be needed if ur bed adhesion is weaksauce 
Use supports for better results

PS. I thought i fixed the file but printed one out and it didnt fit right, so i thermoformed mine by boiling a tiny bowl of water in the microwave and dipped the end of the part into the water, (making sure not to get the botto