Flux Engine (Stand-alone)

## A stand-alone FluxEngine based on the magnificent work done by David Given
(http://cowlark.com/fluxengine/)

### ~~This project is in active development.~~ Project development currently on hold for re-evaluation.
### Current status is:
* hardware 100%,
* software 10%,
* 3d-printed parts design: 99%


~~I plan to create a video of the complete assembly.~~
I am no longer planning to create an assembly video for a number of reasons.
* The build I am currently using is a development build with port extenders (USB, HDMI, LAN) so the video would not be representative.
* The build is not difficult to figure out without visuals but it is a tedious job which I don't like to repeat over and over to get a good video.
* Response to this design has been disappointing and I probably will change a lot in the coming months.

### Incompatibilities:

The current back-panel uses a USB-C port with a power delivery PCB. In recent testing I found the board to be underperforming (tha