FLUX Engraving Toolhead

Use a commercially available engraving pen to create FLUX's new engraving tool head
With FLUX Studio Draw Function

Test Result
The motor is not suitable for USB voltage, burn after 10 minutes of operation.
After replacing the new one, engraving wood is no problem (Height down 0.1mm each time)
Not suitable for carving metal, because the level is a big problem,
the height can not drop too much (0.05mm),but level different is bigger than it
Power also not enough for metal engrave

Notice:
Only fit for FLUX Delta Pen Holder Tool
Be sure the height setting is OK before Start
There is an height detector for replace before you start
Printing tolerance should be check by yourself ,I use 0.2 nozzle for hotend

Demo:
https://photos.app.goo.gl/eRxpVlJZqH8Dphf02