Flying Bear Ghost 5 Direct

Direct for a bear from one detail.
-Does not steal the x-axis
- The rigidity of the design allows the extruder to sit tightly and not wobble
-Dives under the perimeter of the top edge of the printer
-The only printable part that does not require support
-Has a rigid support with M2.5 screws for the X-axis belt box
-Does not creep left/right
- Allows you to use bowden in a spreader, without clamps

bowden (head-extruder) is at an angle of 25-30 degrees.

Instruction
Print the left flat side of the crab on the table.
cut the bowden to the desired length
assemble the extruder body, insert it under the plastic clamp into the crab,
a short screw is screwed in on the side of the folding flag of the extruder,
hexagon through the extruder body,
squeeze the crab to the head so that the belt flag dives into the groove in the crab,
at the same time, we monitor the bowden bend avoiding deformations
move the crab as far as possible to the right, tighten the screws 2.5mm, you need