MakerWorld
Other Props & Cosplays
Zum Modell
Flying Dutchman
69
Downloads
50
Likes
3
Makes
Model of the flying dutchman star carrier from book series Expeditionary Force. Based off of cover art on the books and other images posted online by R.p. Callahan who did the original artwork for Craig Alanson. This model is almost 12' long and a large project. It does require in addition to the 3D printed parts a piece of 19mm round tubing that the pieces slide onto. I used a piece of anodized aluminum as that is what I had on hand but I think a piece of ¾" steel plumbing pipe should work as well or possible a piece of steel electrical conduit. For the lighting I used some RGBZONE JST 2 -Pin Connectors, some 3mm LED Lights and some LED tape. I made a couple of adjustments to the spine sections B and C on build plates 16 and 17. The originals will work since it is what I used but the new ones will fit together much better as there is a better fit for the seal rings. Also added some additional STEP files for some pipe sections that can be connected together and used in place of
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!