Flying Wing Buratinu

The Buratinu is a smaller derivate of the Buratino which was designed by Bil in St. Petersburg.
Thank you Bil for the great design.
With its pointed nose I was optimistic that I would manage the CG problem, which is always tricky with printed planes.
The original has a wingspan of 1800 mm. I designed it for a wingspan of 1300 mm with slightly more sweep back.

The video is on YouTube https://www.youtube.com/watch?v=HTmxjgw0Mq4&t=165s



Helmut uploaded a great video to show how to launch it by hand:


And this is the exciting maiden of Peter's Buratinu - inclusive stress test ;)





Detailed information about the development from the beginning and a lot pictures of the parts can be found on rc-network
http://www.rc-network.de/forum/showthread.php/682097-Drohne-aus-St-Petersburg-drucken

Recommended Print Settings
Attention
The wings are designed to print using 0.5 mm width, 4 bottom and 4 top
layers, no infill, 1 perimeter only.
Should you print thinner wa