flying wing glider V3

small flying wing glider third version of small 3D printed gliders I've made.Inspired by a foam board glider I've made in the past which was subsequently inspired by the gliders in this video improvementsmuch more stablecan fly at much lower speeds much better glide ratiorequires little to no trimrequires little force to launchbefore flightuse tape/super glue/hot glue (hot glue i find is the easiest) to connect the middle section of the wing to the rest of the glider.angle the tabs on the wing tips upwards (will act as elevon trim)launching(throwing it from head causes the glider to roll)pinch the trailing edge of the middle sectionthrow in a straight lineBoost Me