Thingiverse
FlyingBear Ghost Direct Drive MOD
von tonycstech
48
Downloads
41
Likes
0
Makes
https://youtu.be/yoUWE9HrtGs
#Finally i present to you the DIRECT DRIVE
for FlyingBear Ghost revision 3 printer.
This mod uses original wiring and end switch, are all mounted to the carriage.
Designed for E3D V6 Extruder.
REUSE original feeder.
Comes in 2 configurations, original and V2.
V2 is to use with 40mm blower fan
Read Instructions for more information on firmware changes requirement and other info.
#Finally i present to you the DIRECT DRIVE
for FlyingBear Ghost revision 3 printer.
This mod uses original wiring and end switch, are all mounted to the carriage.
Designed for E3D V6 Extruder.
REUSE original feeder.
Comes in 2 configurations, original and V2.
V2 is to use with 40mm blower fan
Read Instructions for more information on firmware changes requirement and other info.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
