Thingiverse
FlyingBear Omkqn autosensor mount.
por ThriDee
10
Descargas
5
Likes
0
Makes
Auto bed leveling sensor mount for Flying bear
Needs 2 pcs of M3 x 6 mm screws to mount to underside of the Extruder carriage using the M3 mounting holes.
Make sure the M3 screw heads are above the height of extruder tip to prevent damage to your bed.Do not use screws longer than M3*6 mm.
I am not responsible for any damage to your bed from improper mounting.Use at your own risk.
Needs 2 pcs of M3 x 6 mm screws to mount to underside of the Extruder carriage using the M3 mounting holes.
Make sure the M3 screw heads are above the height of extruder tip to prevent damage to your bed.Do not use screws longer than M3*6 mm.
I am not responsible for any damage to your bed from improper mounting.Use at your own risk.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!